|
PA7/PA15/PA36/PA54 Power Amplifier
Airborne Telemetry/Transmitters & Power
Amplifers
 Power Amplifiers are used to boost
the transmission range of a RF signal where a higher power
transmitter cannot be obtained or larger antenna size cannot
be used to provide the required gain. Applications include
Airborne and Ground Telemetry, Data, or Video links to terrestrial
or space receiving sites. Linear and Class C designs areavailable.
Amplifiers operating at 1,000 MHz or higher include internal
isolators to protect the amplifier circuitry foropen or shorted
load conditions. Isolators and Low Pass Filters for units
operating below 1,000 MHz are optional.Amplifiers are available
with up to 250 watts output in the VHF, UHF, L, S, and in
lower output power models for C, and X-Bands. Housing sizes
and output power capabilities are application specific and
vary depending on input/output power requirements, bandwidth,
and signal type. High power models are available in NEMA
style outdoor, weather-resistant enclosures. Standard housing
sizes available include:
 PA7
7 Cubic Inches
PA15 15 Cubic Inches
PA36
36 Cubic Inches (shown)
PA54 54 Cubic Inches
Other sizes
to meet specific application requirements are available.
Physical
size dependant on Output Power,Operating Frequency,
and Bandwidth. Contact factory or nearest Representative
with
your specific
requirements. Amplifiers may be co-located with
the corresponding transmitter or mounted on the transmitter
if housing
sizes are compatible. Connector types and configurations
can
be customer-specified. In most cases, heatsinking
is
required.
Click
here for PA7 / PA15 / PA36 / PA54 data sheet
 .pdf
format
Specifications subject
to change
without notice
|
